Both temp are set at 69 degrees.
2014 ford edge blend door actuator drivers side.
Driver side blend door actuator replacement.
16 people found this helpful.
Turned on ac getting cold air out of vents on drivers side.
Temporary solution is to press the climate control button and the then defrost at the same time this will reset the ac to door on the actuator to reset.
The blend door actuators are located right on the heater box behind the dash.
I assuming driver side is more.
Temp gage is lo.
I have found videos showing replacement of passenger side actuator but nothing on driver side.
Sounds like a temperature blend door mechanism issue in the dash.
Blend door actuator replace.
Ford has released technical service bulletin tsb 14 0038 for a programming update on the hvac module for issues with the climate control being stuck on hot or cold.
The actuator on the driver s side is located down below the dash above the brake and accelerator pedals.
I have a 2014 ford edge with dual climate controls.
The actuator that changes temperature is good the actuator that doesn t is bad.
What could possibly causing thi.
If the door mechanically moves as it should but the actuator won t replace the rh temperature blend door actuator.
Ford edge with keyless entry system 2014 front driver side door lock actuator motor by genuine.
I went ahead and unplugged the hvac actuator while the car was running and plugged it back in presto problem solved.
The drivers side is blowing out hot air and the passenger side is blowing cool air.
Very hot air blows on passenger side.
Hi james replacement of the blend door actuator is not needed.
My wife s 2013 ford edge sport was blowing hot air on driver s side and cold air on passenger side.
Questions ford ford explorer 2014 ford explorer.
If your electrical parts are in need of repair don t compromise the performance and safety of your car with suspect off brand.
2013 ford edge ac drivers side heater on passenger side 1 answer.
This test also proves out the hvac controller.
If the controller is bad neither actuator would change positions.